Kirami Wood Treatment Oils & Stains


Keep your Kirami wood fire hot tub looking a new as possible with our range of wood treatment products.

Stained Spruce surfaces can be treated with Teknos Tecknoshield stain.
Thermowood and Red Cedar can be treated with wood oil with UV filter.

Composite panels only need to be washed every once in a while.

When treating the tub panels, you can remove the outer hoops or cover them with adhesive tape during treatment, immediately removing any splashes or runoffs.

Maintenance of your hot tub ensures a longer lifespan. With these stains and oils you can return the hot tub to the original Kirami colour. Stains and oils are both protective and decorative.

A 1 litre tin is sufficient for hot tubs with a diameter of 150cm to 220cm. Oils are only available in 2.5l tins. This will be sufficient for multiple tubs or years of treatment assuming stored in a cool dry place.

Product Id: N/A Category:
  • Preparation
    Cedar Oil and Thermowood Oil work best on unfinished timber. Previous finishes which stop Oil penetrating into the timber (e.g. paint and other ‘closed’ finishes) must be fully removed prior to application. Previous porous finishes can be lightly sanded before overcoating. When overcoating a previously finished surface, a trial application is essential. Flaking or peeling finishes must be fully removed prior to application. Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust etc. Timbers susceptible to decay, mould and fungi should be treated first with a suitable preservative. We advise that when using Oil, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use. Timber must have a moisture content below 18%. Temperature must be between 8º and 25º during application and drying. We strongly recommend a trial application prior to starting the project.

    Stir tins thoroughly, before and during use. Use a brush or roller to evenly apply Oil in the same direction as the wood grain. Pay particular attention to end grain, on end grain apply liberally. If possible, treat all sides of the timber for the first coat. After approximately 12 hours the first coat can be overcoated. Apply with a brush or roller a second coat of Oil. After the second coat leave for approximately 12 hours to dry. Oil is not a surface building product.

    Red Cedar Oil Safety Data Sheet
    Thermowood Oil Safety Data Sheet

  • Weight 2 kg

    DarkWalnut Stain 1l, CoalBlack Stain 1l, Thermowood Oil 2.5l, Red Cedar Oil 2.5l



  • Smaller items will be delivered using royal mail, courier or palleted delivery and priced accordingly. Hot tub & sauna delivery costs will depend on the following, which are set as options during checkout. If uncertain which apply please contact us before placing your order.

    • The width of the access to the hot tub or sauna location.
    • Whether the location is accessible via road or driveway.
    • The number of locations if multiple products are ordered.
    • Whether product installation is also required.

Alternative Products